This reply was modified 1 year, 8 months ago by Nikos Lygizos. Especially from the MTC4PU “missing” commands, I think. Initially, is working great except some delayed actions. In those cases, the decoder needs to stop before implementing the change of direction. This is important when two consecutive commands are sent, and especially critical if a change of direction is requested. You will have to re-program all you MattzoControllers with the IP of this Raspberry Pi, unfortunately. This low-cost decoder needs some pause after any speed change request to actually reach the new speed. Enter the following commands to create a Rocrail button:. ROCRAIL MANUAL MANUALIn semi-automatice or manual mode only the locomotives you run in the software are locked out. ROCRAIL MANUAL FULLIn full automatic mode that would mean all locomotives registered in the Loco Table as shown in the left part of the Rocrail window below. Using your RealVNC login to the Pi Desktop and start a terminal (ssh) window. In Rocrail I believe the Navigators are only locked out for the locomotive IDs which the software are in control of.System Options –> Boot/Auto Login –> Desktopĭisplay Options –> Resolution –> Any but default (monitor limitations) ssh back to the Pi using the new password. ROCRAIL MANUAL UPDATE
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |